By Published on

Brakes

How it looked before:

The brake vacuum servo was ok, diaphragm was holding pressure it just needed a quick refresh. It was pretty hard to tape it up for media blasting and don't let the particles in. After cleaning it up, you know the deal: epoxy + acrylic topcoat.

Same goes for master cylinder.

Front calipers are pretty clever design and can be taken apart with just screwdriver to pry on two springs.

They were media blaster as well (Polgrit 80) and zinc plated.

You may choose not to have a unique web analytics identification number assigned to your computer to avoid the aggregation and analysis of data collected on this website.

For more information please see Data & privacy note here

To make that choice, please click below to receive an opt-out cookie.